This is a working overview of neurotrophic factor, written for readers who want more than a one-paragraph summary but less than a textbook.
Reviewed 2026-03-23. Anything still debated is marked as such rather than presented as settled.
Once dissolved, the peptide is considerably less stable than the solid. Aqueous solutions are usually prepared at neutral to slightly acidic pH, filtered, and divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are a common cause of avoidable loss and are best prevented by never refreezing a thawed aliquot. Adsorption to plastic and glass surfaces can lower the measured concentration of dilute solutions, particularly below roughly 0.1 mg/mL. Buffer choice, salt content, and container material all influence how much peptide remains detectable after storage.
Identity and purity are established with standard peptide methods. Reversed-phase HPLC with ultraviolet detection near 214 nm resolves the parent peak from deletion and truncation byproducts, and reports typically quote a main-peak percentage. Mass spectrometry by electrospray or MALDI-TOF confirms the expected molecular mass, while amino acid analysis or peptide mapping can verify composition when the sequence itself is in question. A certificate of analysis that pairs a chromatogram with a mass spectrum is more informative than a purity figure alone. Counter-ion content and residual solvents are separate specifications and are frequently omitted.
Semax is normally supplied as a lyophilized powder, and that form is the most stable. Suppliers commonly recommend storage at -20 °C in a desiccated container protected from light, with short-term handling at room temperature limited to weighing and transfer. Powder that has absorbed moisture degrades faster, so vials should be warmed to ambient temperature before opening to prevent condensation on the contents. Hygroscopic behavior is typical of short hydrophilic peptides, and humidity control matters more than temperature alone for long-term retention.
Development took place during the 1980s at institutes of the Russian Academy of Sciences, where peptide fragments of ACTH were screened for cognitive and neuroprotective effects. The compound received regulatory approval in Russia as a nasal preparation, marketed for conditions such as ischemic stroke, transient ischemic attacks, and optic nerve disorders. Registration in other countries has not followed. Most published clinical reports originate from a small number of Russian research groups, and independent replication outside that setting remains limited. The regulatory status therefore differs sharply between Russia and the rest of the world.
Laboratory work points toward modulation of neurotrophic signaling, particularly expression of brain-derived neurotrophic factor and nerve growth factor in hippocampal tissue. Studies also describe effects on monoamine turnover, inflammatory mediators, and oxidative markers. These observations come mainly from animal models and cultured cells, so the causal chain in humans is not firmly established. Whether the reported molecular changes translate into measurable clinical benefit is an open question. Reviews generally present the mechanism as plausible rather than demonstrated.
Clinical evidence consists largely of small trials with modest sample sizes, often without independent replication. Reported endpoints include cognitive scores, recovery after stroke, and visual function, but study designs vary widely and few trials meet contemporary reporting standards. Systematic reviewers have noted a high risk of bias in several of these reports. No large multicenter trial conducted outside Russia has been published. The compound is therefore best described as investigational in most jurisdictions, with its clinical role still unresolved.
| Property | Value | Notes |
|---|---|---|
| Solid storage temperature | -20 °C or below | Desiccated and protected from light |
| Solution storage temperature | -80 °C as single-use aliquots | Avoid repeated freeze-thaw cycles |
| Purity assessment method | RP-HPLC, around 214 nm | Reported as main-peak area percent |
| Identity confirmation method | ESI-MS or MALDI-TOF | Measured mass compared with calculated mass |
| Common synonyms | ACTH(4-10) analog; Met-Glu-His-Phe-Pro-Gly-Pro | Also written as Semaxum in some sources |
Published research covers ischemic stroke, traumatic brain injury, cognitive impairment, optic nerve conditions and attention-related measures. Much of the human evidence comes from small trials conducted in one country, which limits how far the results generalize. Animal models supply the larger share of the data, and effects seen in rodents do not transfer automatically to people. Reviews have noted that methodological reporting is often incomplete, making it difficult to pool results or compare treatment schedules across studies.
Pharmacokinetic accounts emphasize rapid breakdown. After intravenous dosing the intact peptide disappears from blood within minutes, and nasal delivery produces low but measurable concentrations. Metabolites rather than the parent molecule may account for part of the observed activity, although the relative contribution is unresolved. Dosing in the literature varies widely and no optimal schedule has been agreed. These gaps are regularly cited as a reason the findings have not produced broad clinical adoption beyond the original research setting.
Proposed mechanisms center on neurotrophic signaling rather than on classical melanocortin receptor activation. Rodent experiments have reported shifts in the expression of brain-derived neurotrophic factor and nerve growth factor after administration, together with changes in the associated receptor systems. Several authors argue that the peptide acts largely through its degradation products and their interaction with peptidergic pathways, but this remains a hypothesis rather than a settled finding. No single molecular target has been identified in a way that the field broadly accepts.
Later generations of the molecule include an N-acetylated form and an amidated form, both marketed online alongside the parent peptide. These variants differ in terminal chemistry and stability, and they are frequently discussed in the same breath even though they have not been compared in controlled trials. Supply outside formal healthcare systems comes largely from laboratories that synthesize peptides to order. Purity and identity of these materials vary widely, and no single body oversees the international trade.
Semax is a synthetic heptapeptide developed in the Soviet Union during the 1980s by researchers at the Institute of Molecular Genetics in Moscow. It was designed as a truncated analog of adrenocorticotropic hormone, retaining only the fragment spanning residues four through ten. Investigators sought a peptide that would preserve the cognitive effects associated with ACTH while eliminating the hormonal stimulation of the adrenal cortex. The compound entered clinical use in Russia during the following decade.
Russian regulatory authorities approved the peptide for nasal administration, and it remains listed in the national pharmacopoeia under several trade names. Documented indications include acute ischemic stroke, transient ischemic attacks, traumatic brain injury, and certain ophthalmological and neurological conditions. Physicians also prescribe it for cognitive complaints in older patients, although the evidence base for that use is thinner. Outside Russia and a few neighboring states, the substance is not an approved medicine and is sold instead as a research chemical.
Purity assessment relies mainly on reversed-phase high-performance liquid chromatography, which separates the target heptapeptide from truncated sequences, deletion analogues, and oxidised forms. Mass spectrometry, usually coupled to liquid chromatography, confirms identity through the expected molecular ion and reveals modifications such as methionine sulfoxide formation. Amino acid analysis can verify composition, and tandem mass spectrometry supports sequence confirmation. Ultraviolet detection near 254 to 280 nanometres is convenient because the phenylalanine and histidine residues absorb in that region. Nuclear magnetic resonance is rarely used for routine release testing.
Common degradation pathways include oxidation of the methionine side chain, hydrolysis of the peptide backbone, and aggregation under unfavourable pH or concentration. Stability studies typically monitor the main peak by chromatography and report total related substances as a percentage. Because no official monograph exists, acceptance criteria vary between laboratories, and reported purity values are not directly comparable across suppliers. Analysts therefore document the method, column, and detection wavelength alongside each result, and open questions remain about how much biological activity the oxidised forms retain.
The history of penicillin traces how observations of antibiotic activity in the mould Penicillium led to the development of penicillins, a family of widely used antibiotics. Ancient societies used moulds to treat infections, and many people observed the inhibition of bacterial growth by moulds. While working at St Mary's Hospital in London in 1928, Scottish physician Alexander Fleming was the first to show experimentally that a Penicillium mould secretes an antibacterial substance, which he named "penicillin". The mould was found to be a variant of Penicillium chrysogenum (now called Penicillium rubens), a contaminant of a bacterial culture in his laboratory. The work on penicillin at St Mary's ended in 1929. In 1939, a team of scientists at the Sir William Dunn School of Pathology at the University of Oxford, led by Howard Florey, which included Edward Abraham, Ernst Chain, Mary Ethel Florey, Norman Heatley and Margaret Jennings, began researching penicillin. They developed a method for cultivating the mould and extracting, purifying and storing penicillin from it, together with an assay for measuring its purity. "Penicillin" now became the name of the active ingredient in the mould juice. They carried out experiments on animals to determine penicillin's safety and effectiveness before conducting clinical trials and field tests. They derived penicillin's chemical formula and determined how it works. The private sector and the United States Department of Agriculture located and produced new strains and developed mass production techniques.
==== United Kingdom ==== In February 2024 Zipline posted adverts on LinkedIn for "Flight Operations Lead", "Head of Business Operations" and "Flight Operator / Maintenance Technician" in Newcastle upon Tyne.
== Biomarkers of reproductive health == The main neohormones that can be used as biomarkers of reproductive health are relaxin, oxytocin, hCG, INSL3, and INSL5 and INSL6. Relaxin (Specifically Ovarian H2-relaxin) aids in the implantation of the embryo into the uterine wall after fertilisation, as well as establishing the placenta. The levels of relaxin are altered in cases of early miscarriage and hence can be used as a biomarker during early pregnancy. Oxytocin has a range of functions in the reproductive systems of both males and females. It has a major role in the production of breast milk and lactation. It is responsible for muscle contractions in the uterus to facilitate birth. It also assists in ovarian steroid production and ovum release. In men, oxytocin has a role in erections and ejaculation. It also participates in gonadal development in both males and females. Despite being tricky to measure, measuring oxytocin can help build a clinical picture of reproductive health in the above mechanisms. hCG has a vital role in early pregnancy. Higher levels of hCG is a good indication for the survival and viability of the embryo. β-hCG can be monitored to test for an ectopic pregnancy. INSL3 is responsible for the first phase of testicular descent in males and may be disrupted in cases of cryptorchidism. It also acts as a measure of Leydig cell function, particularly in older males. INSL5 and INSL6 may have a role in spermatogenesis.
Sources: en.wikipedia.org
=== Degradation === Histidine can be metabolized into glutamate, which is readily metabolized into AKG (alpha-ketoglutarate), making histidine one of the amino acids whose metabolites can become citric acid cycle intermediates. The process requires several steps. In prokaryotes, histidine first undergoes deamination, the removal of its amino group by the emzyme histidase. This step produces ammonia and urocanic acid (urocanate). The enzyme urocanase then converts urocanic acid into imidazolonepropionate (4-imidazolone-5-propionate). The enzyme imidazolonepropionase then converts imidazolonepropionate into formiminoglutamate (FIGLU). The enzyme formimidoyltransferase cyclodeaminase removes the formimino group (which is transferred to tetrahydrofolate), leaving behind a glutamate molecule. Glutamate can then be deaminated by glutamate dehydrogenase or transaminated to form α-ketoglutarate.
The bicyclic core of C10-epi-kedarcidin chromophore was prepared by the sequential application of three carbon-carbon bond forming reactions, as shown in the retrosynthetic schematic above. First, a Sonogashira coupling was carried out between a bromovinyl electrophile and alkynyl nucleophile; ring closure to give a cyclic triyne was then accomplished by Glaser coupling of two terminal alkynes. The 5,9-fused bicyclic core was established by in situ generation of a vinyllithium species that underwent transannular 5-exo-dig cyclization.
A eukaryotic initiation factor eIF3 plays an important role in translational initiation. It has a complex structure, composed of 13 subunits. It helps to create the 43S pre-initiation complex, composed of the small 40S subunit attached to other initiation factors. It also helps to create the 48S pre-initiation complex, consisting of the 43S complex with the mRNA. The eIF3 factor can also be used post-translation in order to separate the ribosomal complex and keep the small and large subunits apart. The initiation factor interacts with the eIF1 and eIF5 factors used for scanning and selection of the start codons. This can create changes in the selection of the factors, binding to different codons. Another important eukaryotic initiation factor, eIF2, binds the tRNA containing methionine to the P site of the small ribosome. The P site is where the tRNA carrying an amino acid forms a peptide bond with the incoming amino acids and carries the peptide chain. The factor consists of an alpha, beta, and gamma subunit. The eIF2 gamma subunit is characterized by a GTP-binding domain and beta-barrel folds. It binds to the tRNA through GTP. Once the initiation factor helps the tRNA bind, the GTP hydrolyzes and is released the eIF2. The eIF2 beta subunit is identified by its Zn-finger. The eIF2 alpha subunit is characterized by an OB-fold domain and two beta strands. This subunit helps to regulate translation, as it becomes phosphorylated to inhibit protein synthesis.
=== Common resins === DEAE-C is commonly commercially available as DE52 and DE53. These resins are prepared preswollen although cellulose exchangers swell in a strong basic environment to increase access to binding sites. DE52 has a pKa of 11.5. The buffering range for diethanolamine is 8.4-8.8, though the range for DEAE-C varies between manufacturers.
Sources: en.wikipedia.org
Each freeze-thaw cycle can degrade a fraction of the peptide and promote aggregation. Dividing a stock solution into single-use volumes removes repeated cycling as a variable. It also limits the time a thawed solution spends at room temperature.
A high main-peak percentage says little about identity, counter-ion content, or residual solvents. It also does not distinguish an isomer or a closely eluting analog. Mass confirmation and the accompanying documentation cover those gaps.
Salt form changes mass, solubility, and hygroscopicity, and acetate and trifluoroacetate salts behave differently in solution. Storage guidance still centers on -20 °C for powder and lower temperatures for solutions. The certificate should state which salt is present.
Semax is a synthetic seven-amino-acid peptide derived from a fragment of corticotropin. It is used in Russia as a nasal preparation, while elsewhere it is studied as a research compound. It is not approved as a medicine in most countries.