If you have been reading about RP-HPLC and want a single page that covers the useful parts, this is it: definitions, context, how it is studied, and the questions that come up repeatedly.
Updated 2025-09-02. Numbers and descriptions here follow the published literature rather than marketing material.
Published studies examine a fairly narrow set of endpoints. Rodent experiments commonly measure maze learning, infarct volume after induced ischemia, and tissue levels of neurotrophic factors. Clinical reports from Russian centres describe attention, memory and recovery scores in patients after stroke or transient ischemic attack. Most of those human studies are small and few have been repeated by independent groups. Outcome measures differ between studies, which limits direct comparison.
Circulation time for the peptide is short because peptidases cleave it readily. The Pro-Gly-Pro tail is thought to slow breakdown compared with the bare ACTH fragment, but the gain appears modest. Absorption after intranasal dosing is limited, and only a fraction of a dose is expected to reach the central nervous system. Laboratory concentrations therefore sit well above levels achieved systemically, a gap that complicates translation from bench findings to clinical claims.
Identity and purity of semax are established with reversed-phase high-performance liquid chromatography coupled to ultraviolet detection, usually at 214 nanometres. Mass spectrometry, most often electrospray ionisation in positive mode, confirms the molecular mass and reveals truncated sequences. Amino acid analysis and peptide mapping after enzymatic digestion provide additional structural confirmation. Laboratories typically report purity as the percentage area of the main peak, a figure that does not capture isomeric or oxidised variants unless the method resolves them.
The peptide is prone to several degradation pathways. Oxidation of the methionine residue produces a sulfoxide that elutes close to the parent peak in many chromatographic systems. Hydrolysis of peptide bonds and deamidation of susceptible residues in related sequences also reduce purity over time. Lyophilised material kept dry at minus twenty degrees Celsius and shielded from light is the most stable form commonly described in laboratory practice.
Material sold for laboratory use varies widely in stated purity and documentation. A certificate of analysis should list the analytical method, the column and detector used, and the observed purity value. Independent verification by an outside laboratory is the practical way to confirm identity when documentation is absent or internally inconsistent. Regulatory status differs by country, and a product legal in one jurisdiction may be unapproved or controlled in another.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Lyophilized solid from research suppliers |
| Solubility | Freely soluble in water | Also dissolves in aqueous buffers; solutions are used fresh |
| Typical storage temperature | -20 °C for lyophilized powder | Short-term transport at 2-8 °C is common |
| Common analytical method | Reverse-phase HPLC | Paired with mass spectrometry for identity confirmation |
| Common synonyms | ACTH(4-10) analogue; MEHFPGP | N-terminal methionine retained in the chain |
Stability depends heavily on physical state. Lyophilized powder held dry, cold and dark retains its content over long periods, whereas dissolved peptide begins to change within days at room temperature. The most cited degradation route is oxidation of the methionine residue, which converts the peptide to a sulfoxide form that elutes differently on chromatography. Hydrolysis of amide bonds and adsorption onto container walls contribute smaller losses. Buffers that exclude oxygen from the headspace slow the oxidation pathway, but no single condition prevents all change indefinitely.
Practical handling follows from those properties. Bulk material is best divided into single-use portions soon after receipt, because each thaw exposes the whole container to moisture and temperature cycling. Vials should be allowed to reach room temperature before opening to prevent condensation on the powder. Low-binding plasticware reduces loss of dilute solutions, and sterile filtration is used when a preparation must remain free of microbial growth. Records of batch number, reconstitution date and storage history are what allow a later analytical result to be interpreted meaningfully.
Identity and purity of Semax are established mainly by reversed-phase high-performance liquid chromatography coupled with mass spectrometry. The chromatographic trace gives a purity estimate as a percentage of total peak area, while electrospray or matrix-assisted laser desorption ionization confirms the molecular mass against the calculated value. Amino acid analysis and sequence-specific fragmentation provide further confirmation when a supplier's chain of custody is unclear. Vendors frequently quote a purity figure without stating the detection wavelength or the integration method, which limits how far one number can be compared with another.
Semax is normally supplied as a lyophilized powder, and that form is the most stable. Suppliers commonly recommend storage at -20 °C in a desiccated container protected from light, with short-term handling at room temperature limited to weighing and transfer. Powder that has absorbed moisture degrades faster, so vials should be warmed to ambient temperature before opening to prevent condensation on the contents. Hygroscopic behavior is typical of short hydrophilic peptides, and humidity control matters more than temperature alone for long-term retention.
Once dissolved, the peptide is considerably less stable than the solid. Aqueous solutions are usually prepared at neutral to slightly acidic pH, filtered, and divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are a common cause of avoidable loss and are best prevented by never refreezing a thawed aliquot. Adsorption to plastic and glass surfaces can lower the measured concentration of dilute solutions, particularly below roughly 0.1 mg/mL. Buffer choice, salt content, and container material all influence how much peptide remains detectable after storage.
Identity and purity are established with standard peptide methods. Reversed-phase HPLC with ultraviolet detection near 214 nm resolves the parent peak from deletion and truncation byproducts, and reports typically quote a main-peak percentage. Mass spectrometry by electrospray or MALDI-TOF confirms the expected molecular mass, while amino acid analysis or peptide mapping can verify composition when the sequence itself is in question. A certificate of analysis that pairs a chromatogram with a mass spectrum is more informative than a purity figure alone. Counter-ion content and residual solvents are separate specifications and are frequently omitted.
Hyperglycemia is an unusually high amount of glucose in the blood. It is defined as blood glucose level exceeding 6.9 mmol/L (125 mg/dL) after fasting for 8 hours or 10 mmol/L (180 mg/dL) 2 hours after eating. Postprandial hyperglycemia (PPHG) is abnormal blood sugar elevation after eating (postprandial means after a meal).
increase in the plasma concentration of angiotensin III, a metabolite of angiotensin II increase in plasma angiotensin II, ACTH, or potassium levels, which are present in proportion to plasma sodium deficiencies. (The increased potassium level works to regulate aldosterone synthesis by depolarizing the cells in the zona glomerulosa, which opens the voltage-dependent calcium channels.) The level of angiotensin II is regulated by angiotensin I, which is in turn regulated by renin, a hormone secreted in the kidneys. Serum potassium concentrations are the most potent stimulator of aldosterone secretion. the ACTH stimulation test, which is sometimes used to stimulate the production of aldosterone along with cortisol to determine whether primary or secondary adrenal insufficiency is present. However, ACTH has only a minor role in regulating aldosterone production; with hypopituitarism there is no atrophy of the zona glomerulosa. plasma acidosis the stretch receptors located in the atria of the heart. If decreased blood pressure is detected, the adrenal gland is stimulated by these stretch receptors to release aldosterone, which increases sodium reabsorption from the urine, sweat, and the gut. This causes increased osmolarity in the extracellular fluid, which will eventually return blood pressure toward normal. adrenoglomerulotropin, a lipid factor, obtained from pineal extracts. It selectively stimulates secretion of aldosterone. The secretion of aldosterone has a diurnal rhythm.
== Diagnosis == Typically, seborrhoeic dermatitis is a clinical diagnosis based on a physician's expertise in identifying and differentiating skin conditions based on the history of the individual and the appearance of the skin. Seborrhoeic dermatitis may also be diagnosed with additional testing. The least invasive test is a visual inspection in the clinic using a Wood's lamp. A KOH test can also be used, where skin scraping of the affected skin may also be taken and prepared with potassium hydroxide (KOH) and visualized under a microscope to look for Malassezia or other microbiological cells. Additionally, a fungal culture of the affected skin may be taken to attempt to grow and identify the causative organism.
Sources: en.wikipedia.org
II. Full-thickness defects Full-thickness nasal defects are in three types: (i) wounds to the skin and to the soft tissues, featuring either exposed bone or exposed cartilage, or both; (ii) wounds extending through the nasal skeleton; and (iii) wounds traversing all three nasal layers: skin, muscle, and the osseo-cartilaginous framework. Based upon the dimensions (length, width, depth) and topographic locale of the wound and the number of missing nasal-tissue layers, the surgeon determines the rhinoplastic technique for correcting a full-thickness defect; each of the aesthetic nasal subunits is considered separately and in combination.
The enzyme hydrolyses nicotinamide adenine dinucleotide (a cation) to give nicotinamide and adenosine diphosphate ribose (ADP-ribose). Unlike ADP-ribosyl cyclase/cyclic ADP-ribose hydrolase (EC 3.2.2.6), which catalyzes the same reaction, this reaction does not proceed through a cyclic ADP-ribose. This enzyme participates in nicotinate and nicotinamide metabolism and the calcium signaling pathway. Calcium metabolism involves the regulation of the levels of calcium in the body. The role this calcium plays also includes providing enough calcium for bone mineralization. It serves as the basis for the structure and rigidity of bones. Calcium metabolism can lead to a variety of diseases which can involve renal function. High concentrations of calcium can lead to cell death or apoptosis.
During sample preparation, the sample buffer, and thus SDS, is added in excess to the proteins, and the sample is then heated to 95 °C for five minutes, or alternatively 70 °C for ten minutes. Heating disrupts the secondary and tertiary structures of the protein by disrupting hydrogen bonds and stretching the molecules. Optionally, disulfide bridges can be cleaved by reduction. For this purpose, reducing thiols such as β-mercaptoethanol (β-ME, 5% by volume), dithiothreitol (DTT, 10–100 millimolar), dithioerythritol (DTE, 10 millimolar), tris(2-carboxyethyl)phosphine or tributylphosphine are added to the sample buffer. After cooling to room temperature, each sample is pipetted into its own well in the gel, which was previously immersed in electrophoresis buffer in the electrophoresis apparatus. In addition to the samples, a molecular-weight size marker is usually loaded onto the gel. This consists of proteins of known sizes and thereby allows the estimation (with an error of ± 10%) of the sizes of the proteins in the actual samples, which migrate in parallel in different tracks of the gel. The size marker is often pipetted into the first or last pocket of a gel.
== External links == ProtScale (web-based tool for calculating hydropathy plots) NetSurfP - Secondary Structure and Surface accessibility predictor Whole residue hydrophobicity scale Membrane protein explorer
Sources: en.wikipedia.org
== Selected books == J.W. Steed, D.R. Turner, K. Wallace Core Concepts in Supramolecular Chemistry and Nanochemistry (Wiley, 2007) 315p. ISBN 978-0-470-85867-7 Brechignac C., Houdy P., Lahmani M. (Eds.) Nanomaterials and Nanochemistry (Springer, 2007) 748p. ISBN 978-3-540-72993-8 H. Watarai, N. Teramae, T. Sawada Interfacial Nanochemistry: Molecular Science and Engineering at Liquid-Liquid Interfaces (Nanostructure Science and Technology) 2005. 321p. ISBN 978-0-387-27541-3 Ozin G., Arsenault A.C., Cademartiri L. Nanochemistry: A Chemical Approach to Nanomaterials 2nd Eds. (Royal Society of Chemistry, 2008) 820p. ISBN 978-1847558954 Kenneth J. Klabunde; Ryan M. Richards, eds. (2009). Nanoscale Materials in Chemistry (2nd ed.). Wiley. ISBN 978-0-470-22270-6.
Pindolol is a first generation, non-selective beta blocker in the class of β-adrenergic receptor antagonists. On the receptor level it is a competitive partial agonist. It possesses intrinsic sympathomimetic activity, meaning it has some degree of agonist effects in the absence of competing ligands. Pindolol shows membrane-stabilizing effects like quinidine, possibly accounting for its antiarrhythmic effects. It also acts as a serotonin 5-HT1A receptor partial agonist (intrinsic activity = 20–25%) or functional antagonist. The drug additionally shows affinity for the serotonin 5-HT1B receptor.
==== Skin depot ==== The absorption of a chemical deposited on skin can also be modeled using first order terms. It is best in that case to separate the skin from the other tissues, to further differentiate exposed skin and non-exposed skin, and differentiate viable skin (dermis and epidermis) from the stratum corneum (the actual skin upper layer exposed). This is the approach taken in [Bois F., Diaz Ochoa J.G. Gajewska M., Kovarich S., Mauch K., Paini A., Péry A., Sala Benito J.V., Teng S., Worth A., in press, Multiscale modelling approaches for assessing cosmetic ingredients safety, Toxicology. doi: 10.1016/j.tox.2016.05.026] Unexposed stratum corneum simply exchanges with the underlying viable skin by diffusion:
Sources: en.wikipedia.org
It consists mainly of animal experiments and small clinical reports, with much of the clinical material published in Russian-language journals. Large independent trials are scarce. Separating reliable effects from chance findings is consequently difficult.
A fraction of an intranasal dose is thought to reach the central nervous system, and this route is favoured partly for that reason. The proportion is not well characterized. Direct measurement in humans remains difficult with current methods.
Raised BDNF and NGF expression has been reported across several animal studies, which makes the signal fairly consistent. Whether the same change occurs in humans at usable doses is not established. It is best treated as a working hypothesis rather than a confirmed clinical mechanism.
Reversed-phase high-performance liquid chromatography is the standard method, with detection in the ultraviolet range. Peak area percentage yields a purity figure for the main component. Mass spectrometry is normally run alongside to confirm molecular identity.