The short version of intranasal delivery fits in a sentence. The long version — which is the one that helps — is below.
Reviewed 2026-08-01. Anything still debated is marked as such rather than presented as settled.
Published studies examine a fairly narrow set of endpoints. Rodent experiments commonly measure maze learning, infarct volume after induced ischemia, and tissue levels of neurotrophic factors. Clinical reports from Russian centres describe attention, memory and recovery scores in patients after stroke or transient ischemic attack. Most of those human studies are small and few have been repeated by independent groups. Outcome measures differ between studies, which limits direct comparison.
Circulation time for the peptide is short because peptidases cleave it readily. The Pro-Gly-Pro tail is thought to slow breakdown compared with the bare ACTH fragment, but the gain appears modest. Absorption after intranasal dosing is limited, and only a fraction of a dose is expected to reach the central nervous system. Laboratory concentrations therefore sit well above levels achieved systemically, a gap that complicates translation from bench findings to clinical claims.
从分子层面看，Semax 是线性七肽，没有二硫键、糖基或脂链修饰，N 端为游离氨基，C 端为游离羧基。分子含组氨酸与谷氨酸侧链，因此在水和甲醇等极性溶剂中溶解良好，在非极性溶剂中溶解有限。计算分子量约为 814 Da，与其质子化离子的质荷比吻合，可用于质谱确认。
稳定性主要由水解与氧化两条路径支配。肽键在中性或弱酸性条件下相对稳定，遇到强碱或长时间高温则明显断裂；甲硫氨酸侧链容易被氧化成亚砜，使主峰前移并拉低实际含量。金属离子、光照和反复冻融会进一步促进降解或聚集。冻干粉在低温避光条件下可存放较长时间，配制后的水溶液通常需要冷藏并尽快用完。
纯度评估以反相高效液相色谱为主，通过主峰面积百分比给出粗略结果，再配合电喷雾质谱核对分子量。氨基酸分析可验证组成比例，手性色谱或毛细管电泳用于检查残基构型。常见杂质包括缺失序列的短肽、氧化产物与二聚体。由于多数市售品不附带完整检验报告，独立第三方检测常被用来核实标称值。
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Lyophilized solid from research suppliers |
| Solubility | Freely soluble in water | Also dissolves in aqueous buffers; solutions are used fresh |
| Typical storage temperature | -20 °C for lyophilized powder | Short-term transport at 2-8 °C is common |
| Common analytical method | Reverse-phase HPLC | Paired with mass spectrometry for identity confirmation |
| Common synonyms | ACTH(4-10) analogue; MEHFPGP | N-terminal methionine retained in the chain |
Identity and purity are confirmed with reversed-phase high-performance liquid chromatography, typically monitored at 214 nanometres where the peptide bond absorbs. Mass spectrometry, either electrospray or MALDI-TOF, verifies molecular mass against the theoretical value and detects truncation or adduct formation. Amino acid analysis and peptide mapping provide additional confirmation when required. The most frequently reported impurities are deletion sequences from incomplete coupling, methionine sulfoxide from oxidation, and dimeric species formed through non-covalent aggregation. Impurity profiles depend strongly on the synthesis and purification route chosen by the producer.
Published research has focused mainly on neurological and cognitive endpoints in animal models, with proposed mechanisms involving brain-derived neurotrophic factor and related signalling pathways. A substantial share of the human data originates from a limited number of research groups, and independent replication in other countries remains sparse. Regulatory status reflects that distribution: the peptide is registered as a medicine in Russia and appears in some neighbouring markets, while elsewhere it is handled as a research chemical without approved therapeutic labelling. Questions about dose-response relationships, long-term effects, and comparability across studies are still open.
Lyophilised powder is normally kept at -20 °C in a desiccated container, with some suppliers recommending -80 °C for long-term archival storage. Repeated freeze-thaw cycles are the most common cause of avoidable loss, so aliquoting before freezing reduces variability between working sessions. Dissolved peptide is far less stable than the dry solid and is usually prepared fresh or held briefly at 4 °C. Aqueous solutions support both hydrolysis of the backbone and oxidation of the N-terminal methionine, and these two routes dominate degradation under ordinary laboratory conditions.
Identity and purity of semax are established with reversed-phase high-performance liquid chromatography coupled to ultraviolet detection, usually at 214 nanometres. Mass spectrometry, most often electrospray ionisation in positive mode, confirms the molecular mass and reveals truncated sequences. Amino acid analysis and peptide mapping after enzymatic digestion provide additional structural confirmation. Laboratories typically report purity as the percentage area of the main peak, a figure that does not capture isomeric or oxidised variants unless the method resolves them.
The peptide is prone to several degradation pathways. Oxidation of the methionine residue produces a sulfoxide that elutes close to the parent peak in many chromatographic systems. Hydrolysis of peptide bonds and deamidation of susceptible residues in related sequences also reduce purity over time. Lyophilised material kept dry at minus twenty degrees Celsius and shielded from light is the most stable form commonly described in laboratory practice.
Material sold for laboratory use varies widely in stated purity and documentation. A certificate of analysis should list the analytical method, the column and detector used, and the observed purity value. Independent verification by an outside laboratory is the practical way to confirm identity when documentation is absent or internally inconsistent. Regulatory status differs by country, and a product legal in one jurisdiction may be unapproved or controlled in another.
=== Duration of antimicrobials === Delaying or minimizing the use of antibiotics for certain conditions may help safely reduce their use. Antimicrobial treatment duration should be based on the infection and other health problems a person may have. For many infections once a person has improved there is little evidence that stopping treatment causes more resistance. Some, therefore, feel that stopping early may be reasonable in some cases. Other infections, however, do require long courses regardless of whether a person feels better. Delaying antibiotics for ailments such as a sore throat and otitis media may have no difference in the rate of complications compared with immediate antibiotics, for example. When treating respiratory tract infections, clinical judgement is required as to the appropriate treatment (delayed or immediate antibiotic use).
Earthworms travel underground by means of waves of muscular contractions which alternately shorten and lengthen the body (peristalsis). The shortened part is anchored to the surrounding soil by tiny clawlike bristles (setae) set along its segmented length. In all the body segments except the first, last and clitellum, there is a ring of S-shaped setae embedded in the epidermal pit of each segment (perichaetine arrangement). The whole burrowing process is aided by the secretion of lubricating mucus. As a result of their movement through their lubricated tunnels, worms can make gurgling noises underground when disturbed. Earthworms move through soil by several means, depending on species and soil mechanical resistance, either by ingesting it, using root channels or by expanding crevices with force; when forces are measured according to body weight, hatchlings can push 500 times their own body weight whereas large adults can push only 10 times their own body weight.
==== Water shortage and social unrest ==== Protests related to water shortages have become increasingly common in Iran. In July 2021, demonstrations erupted in Khuzestan when citizens accused the government of diverting water resources to support industries and other regions, leaving local communities without sufficient drinking water or irrigation supplies. Similar unrest has occurred in Sistan-Baluchestan, where residents face chronic water shortages exacerbated by mismanagement and illegal water extraction.
Sources: en.wikipedia.org
Methane pyrolysis is an industrial process for "turquoise" hydrogen production from methane by removing solid carbon from natural gas. This one-step process produces hydrogen in high volume at low cost (less than steam reforming with carbon sequestration). No greenhouse gas is released. No deep well injection of carbon dioxide is needed. Only water is released when hydrogen is used as the fuel for fuel-cell electric heavy truck transportation, gas turbine electric power generation, and hydrogen for industrial processes including producing ammonia fertilizer and cement. Methane pyrolysis is the process operating around 1065 °C for producing hydrogen from natural gas that allows removal of carbon easily (solid carbon is a byproduct of the process). The industrial quality solid carbon can then be sold or landfilled and is not released into the atmosphere, avoiding emission of greenhouse gas (GHG) or ground water pollution from a landfill. In 2015, a company called Monolith Materials built a pilot plant in Redwood City, CA to study scaling Methane Pyrolysis using renewable power in the process. A successful pilot project then led to a larger commercial-scale demonstration plant in Hallam, Nebraska in 2016. As of 2020, this plant is operational and can produce around 14 metric tons of hydrogen per day. In 2021, the US Department of Energy backed Monolith Materials' plans for major expansion with a $1B loan guarantee. The funding will help produce a plant capable of generating 164 metric tons of hydrogen per day by 2024.
== Safety == Vacuum flasks are at risk of implosion hazard, and glass vessels under vacuum, in particular, may shatter unexpectedly. Chips, scratches or cracks can be a starting point for dangerous vessel failure, especially when the vessel temperature changes rapidly (when hot or cold liquid is added). Proper preparation of the Dewar vacuum flask by tempering prior to use is advised to maintain and optimize the functioning of the unit. Glass vacuum flasks are usually fitted into a metal base with the cylinder contained in or coated with mesh, aluminum or plastic to aid in handling, protect it from physical damage, and contain fragments should they break. In addition, cryogenic storage dewars are usually pressurized, and they may explode if pressure relief valves are not used. Thermal expansion has to be taken into account when engineering a vacuum flask. The outer and inner walls are exposed to different temperatures and will expand at different rates. The vacuum flask can rupture due to the differential in thermal expansion between the outer and inner walls. Expansion joints are commonly used in tubular vacuum flasks to avoid rupture and maintain vacuum integrity.
== Monitoring == Mold spores are always present in the environment and when conditions are favorable, mold will occur. Regular monitoring of the collection through visual inspection and environmental controls is essential to prevent an outbreak. Mold leaves a visual indication of its presence. Though mold can be any color, gray and black spots coupled with a musty odor can indicate the presence of mold. Books with these indicators can be isolated and treatment steps can be implemented. Books in the surrounding area can be monitored in case of further infestation. Presence of water or condensation and dust are other factors to look out for that can encourage mold growth. Regular cleaning and inspections will help monitor for mold growth. The control and regular monitoring of temperature and humidity levels is vital to prevent mold growth. Guidelines suggest that temperatures be maintained between 65–70 °F (18–21 °C) and relative humidity between 45%-65%. HVAC systems can be utilized and monitored to ensure these levels are maintained. Temperature and humidity values can be systematically measured and recorded to document conditions, to alert of severe fluctuations, and to indicate the functionality of the climate control systems. The systems themselves should be regularly checked for accuracy and functionality.
In geometry, triangle inequalities are inequalities involving the parameters of triangles, that hold for every triangle, or for every triangle meeting certain conditions. The inequalities give an ordering of two different values: they are of the form "less than", "less than or equal to", "greater than", or "greater than or equal to". The parameters in a triangle inequality can be the side lengths, the semiperimeter, the angle measures, the values of trigonometric functions of those angles, the area of the triangle, the medians of the sides, the altitudes, the lengths of the internal angle bisectors from each angle to the opposite side, the perpendicular bisectors of the sides, the distance from an arbitrary point to another point, the inradius, the exradii, the circumradius, and/or other quantities. Unless otherwise specified, this article deals with triangles in the Euclidean plane.
Sources: en.wikipedia.org
The French are also known for their violet syrup, most commonly made from an extract of violets. In the United States, this French violet syrup is used to make violet scones and marshmallows. Viola essence flavours the liqueurs Creme Yvette, Creme de Violette, and Parfait d'Amour. It is also used in confectionery, such as Parma Violets and C. Howard's Violet candies.
=== The analyte is adsorbed onto the electrode surface === Adsorbed species give simple voltammetric responses: ideally, at slow scan rates, there is no peak separation, the peak width is 90mV for a one-electron redox couple, and the peak current and peak area are proportional to scan rate (observing that the peak current is proportional to scan rate proves that the redox species that gives the peak is actually immobilised). The effect of increasing the scan rate can be used to measure the rate of interfacial electron transfer and/or the rates of reactions that are coupltransfer. This technique has been useful to study redox proteins, some of which readily adsorb on various electrode materials, but the theory for biological and non-biological redox molecules is the same (see the page about protein film voltammetry).
β-sheets are formed by H-bonds between an average of 5–10 consecutive amino acids in one portion of the chain with another 5–10 farther down the chain. The interacting regions may be adjacent, with a short loop in between, or far apart, with other structures in between. Every chain may run in the same direction to form a parallel sheet, or in the reverse direction to form an antiparallel sheet, or the chains may form a mixed sheet. The pattern of hydrogen bonding is different in the parallel and antiparallel configurations. Each amino acid in the interior strands of the sheet forms two H-bonds with neighboring amino acids, whereas each amino acid on the outside strands forms only one bond with an interior strand. Looking across the sheet at right angles to the strands, more distant strands are rotated slightly counterclockwise to form a left-handed twist. The Cα-atoms alternate above and below the sheet in a pleated structure, and the R side groups of the amino acids alternate above and below the pleats. The Φ and Ψ angles of the amino acids in sheets vary considerably in one region of the Ramachandran plot. It is more difficult to predict the location of β-sheets than of α-helices. The situation improves somewhat when the amino acid variation in multiple sequence alignments is taken into account.
Sources: en.wikipedia.org
It consists mainly of animal experiments and small clinical reports, with much of the clinical material published in Russian-language journals. Large independent trials are scarce. Separating reliable effects from chance findings is consequently difficult.
A fraction of an intranasal dose is thought to reach the central nervous system, and this route is favoured partly for that reason. The proportion is not well characterized. Direct measurement in humans remains difficult with current methods.
Raised BDNF and NGF expression has been reported across several animal studies, which makes the signal fairly consistent. Whether the same change occurs in humans at usable doses is not established. It is best treated as a working hypothesis rather than a confirmed clinical mechanism.
电喷雾或基质辅助激光解吸电离质谱是常用手段，测得的质子化离子质荷比可换算为分子量。结果与理论值落在合理误差内，才支持结构一致的判断。